SR
−
18
−
STEERING
TILT STEERING COLUMN
1996 LAND CRUISER (RM451U)
11.
INSTALL 3 TENSION SPRINGS
12. INSTALL COMPRESSION SPRING
(a)
Install the 2 bushings to the spring.
(b)
Torque the bolt.
Torque: 7.8 N·m (80 kgf·cm, 69 in.·lbf)
13. INSTALL COLUMN UPPER BRACKET AND COLUMN
UPPER CLAMP
Tighten 2 new tapered
−
head bolts until the bolt head brakes off.
14. INSTALL WIRING HARNESS CLAMP
Tighten the bolt.
15. INSTALL COLUMN HOLE SHIELD, COLUMN HOLE
COVER AND LOWER DUST SEAL
(a)
Install the hole shield to the hole cover.
(b)
Install the dust seal to the hole cover.
(c)
Torque 2 bolts.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
16. CONNECT UNIVERSAL JOINT
(a)
Align the matchmarks on the intermediate No.2 shaft and
universal joint then torque the bolt.
Torque: 34 N·m (350 kgf·cm, 25 ft·lbf)
(b)
Align the matchmarks on the universal joint and the main
shaft then torque the bolt.
Torque: 34 N·m (350 kgf·cm, 25 ft·lbf)
17. CHECK TILT STEERING COLUMN OPERATION
(a)
Check that there is no axial play at the end of the main
shaft.
(b)
With the main shaft in the neutral position, raise the tilt le-
ver and check that the main shaft rises to the uppermost
position.
(c)
Lower the main shaft, and check that it locks in the lower-
most position.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.00 - 12/21/2010
