SA1UI
−
01
SA2650
SST
Z15221
Lithium Base Wheel Bearing
Grease, NIGI No.2
R08387
SST
R08388
SST
−
SUSPENSION AND AXLE
STEERING KNUCKLE AND AXLE SHAFT
SA
−
17
1996 LAND CRUISER (RM451U)
INSTALLATION
1.
INSTALL OIL SEAL TO AXLE HOUSING
Using SST and a hammer, install a new oil seal into the axle
housing.
SST
09618
−
60010
2.
INSTALL OIL SEAL SET
Install these parts to the steering knuckle:
S
Oil seal and retainer
S
Felt dust seal
S
Rubber seal and steel ring
3.
PACK BEARINGS WITH LITHIUM BASE WHEEL
BEARING GREASE, NLGI NO.2
(a)
Place lithium base wheel bearing grease, NLGI No.2 on
your hand.
(b)
Pack grease into the bearing until the grease oozes out
from the outer side.
(c)
Do the same around the bearing circumference.
4.
INSTALL STEERING KNUCKLE AND BEARINGS
(a)
Place the bearings in positions on the knuckle and axle
housing.
(b)
Install the knuckle on the axle housing.
5.
INSTALL KNUCKLE ARM AND BEARING CAP
(a)
Using SST, support the upper bearing inner race.
SST
09606
−
60020
HINT:
Use the SST with a collar.
(b)
Install the bearing cap over the shim that were originally
used.
(c)
Using a hammer, install the bearing cap into the bearing
inner race.
(d)
Using SST, support the lower bearing inner race.
SST
09606
−
60020
HINT:
Use the SST with a collar.
(e)
Using a hammer, tap the knuckle arm and shim into the
bearing inner race.
(f)
Remove the SST from the knuckle.
(g)
Install the 4 cone washers and nuts.
Torque: 96 N·m (980 kgf·cm, 71 ft·lbf)
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.00 - 12/21/2010
