AB0163
Wire Harness
Diameter
Stripped Wire Harness Section
−
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT PASSENGER AIRBAG ASSEMBLY
RS
−
27
1996 LAND CRUISER (RM451U)
(e)
Dispose of the front passenger airbag assembly.
CAUTION:
S
The front passenger airbag assembly is very hot
when the airbag is deployed, so leave it alone for at
least 30 minutes after deployment.
S
Use gloves and safety glasses when handling a front
passenger airbag assembly with deployed airbag.
S
Always wash your hands with water after completing
the operation.
S
Do not apply water, etc. to a front passenger airbag
assembly with deployed airbag.
(1)
When scrapping a vehicle, deploy the airbag and
scrap the vehicle with the front passenger airbag
assembly still installed.
(2)
When moving a vehicle for scrapping which has a
front passenger airbag assembly with deployed air-
bag, use gloves and safety glasses.
2.
DEPLOYMENT WHEN DISPOSING OF FRONT PAS-
SENGER AIRBAG ASSEMBLY ONLY
NOTICE:
S
When disposing of the front passenger airbag assem-
bly only, never use the customer’s vehicle to deploy
the airbag.
S
Be sure to follow the procedure given below when de-
ploying the airbag.
HINT:
Have a battery ready as the power source to deploy the airbag.
(a)
Remove the front passenger airbag assembly.
(See page
RS
−
22
)
CAUTION:
S
When removing the front passenger airbag assembly,
work must be started 90 seconds after the ignition
switch is turned to the ”LOCK” position and the nega-
tive (
−
) terminal cable is disconnected from the bat-
tery.
S
Store the front passenger airbag assembly with the
airbag deployment side facing upward.
(b)
Using a service
−
purpose wire harness for the vehicle, tie
down the front passenger airbag assembly to the tire.
Wire harness: Stripped wire harness section
1.25 mm
2
or more (0.0019 in.
2
or more)
HINT:
To calculate the square of the stripped wire harness section:
Square = 3.14 X (Diameter)
2
divided by 4
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.00 - 12/21/2010