Q08634
TOYOTA Hand
−
held Tester
DLC3
FI3605
ON
OFF
0.13 sec.
Flashing
−
DIAGNOSTICS
AUTOMATIC TRANSMISSION
DI
−
133
1996 LAND CRUISER (RM451U)
(4)
Use the OBD II scan tool or TOYOTA hand
−
held
tester to check the DTCs and freeze frame data.
Note them down (For operating instructions, see
the OBD II scan tool’s instruction book).
(5)
See page
DI
−
143
to confirm the details of the
DTCs.
NOTICE:
When simulating symptoms with an OBD II scan tool (ex-
cluding TOYOTA hand
−
held tester) to check the DTCs, use
the normal mode. For codes on the DTC chart subject to ”2
trip detection logic”, turn the ignition switch off after the
symptoms have been simulated for the 1st time. Them re-
peat the simulation process again. When the program has
been simulated twice, the MIL lights up and the DTCs are
recorded in the ECM.
3.
Check Mode:
INSPECT DIAGNOSIS
HINT:
TOYOTA hand
−
held tester only:
Compared to the normal mode, the check mode has high sens-
ing ability to detect malfunctions. Furthermore, the same diag-
nostic items which are detected in the normal mode can also be
detected in check mode.
(a)
Check the DTC.
(1)
Check the initial conditions.
S
Battery positive voltage 11 V or more.
S
Throttle valve fully closed.
S
Transmission in P position.
S
Air conditioning switched off.
(2)
Turn the ignition switch OFF.
(3)
Prepare the TOYOTA hand
−
held tester.
(4)
Connect the TOYOTA hand
−
held tester to the
DLC3 in the fuse box at the lower left of the instru-
ment panel.
(5)
Turn the ignition switch ON and switch the TOYOTA
hand
−
held tester ON.
(6)
Switch the TOYOTA hand
−
held tester from the nor-
mal mode to the check mode (Check that the MIL
flashes).
(7)
Start the engine (The MIL goes).
(8)
Simulate the conditions of the malfunction de-
scribed by the customer.
NOTICE:
Leave the ignition switch ON until you have checked the
DTCs etc.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.00 - 12/21/2010