BO0632
BO39M
−
01
BO0633
15
°
45
°
N10070
Full Belt Length
minus 200 mm
(7.87 in.)
−
BODY
SEAT BELT
BO
−
93
1996 LAND CRUISER (RM451U)
SEAT BELT
INSPECTION
CAUTION:
Replace the seat belt assembly (outer belt, inner belt, bolts,
nuts or sill
−
bar) if it has been used in a severe impact. The
entire assembly should be replaced even if damage is not
obvious.
1.
All seat belts:
RUNNING TEST (IN SAFE AREA)
(a)
Fasten the front seat belts.
(b)
Drive the car at 10 mph (16 km/h) and make a very hard
stop.
Check that the belt locks and cannot be extended at this
time.
HINT:
Conduct this test in a safe area. If the belt does not lock, remove
the belt mechanism assembly and conduct the following static
check. Also, whenever installing a new belt assembly, verify the
proper operation before installation.
2.
Driver’s seat belt (ELR):
STATIC TEST
(a)
Make sure that the belt locks when pulled out quickly.
(b)
Remove the locking retractor assembly.
(c)
Tilt the retractor slowly.
(d)
Make sure that the belt can be pulled out at a tilt of 15 de-
grees or less, and cannot be pulled out at over 45 degrees
of tilt.
If a problem is found, replace the assembly.
3.
Except driver’s seat belt (ALR/ELR):
STATIC TEST
(a)
Make sure that the belt locks when pulled out quickly.
(b)
Remove the locking retractor assembly.
(c)
Pull out the whole belt and measure the length of the
whole belt.
Then retract the belt slightly and pull it out again.
(d)
Make sure that the belt cannot be extended further.
If a problem is found, replace the assembly.
(e)
Retract the whole belt, then pull it out to the full length mi-
nus 200 mm (7.87 in.).
(f)
Tilt the retractor slowly.
(g)
Make sure that the belt can be pulled out at a tilt of 15 de-
grees or less, and cannot be pulled out at over 45 degrees
of tilt.
If a problem is found, replace the assembly.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.00 - 12/21/2010
