Stoll CMS 730 S, Operating Instructions Manual

Page: 301 / 468

297
5
Setup Data
5.5 Setup2 Editor
YLC5 (tab)
: This tab appears on the CMS only.
An original piece is generated for the YLC5 mode (Masterpiece).

The data will be saved in a separate file (<pattern name>.stx).

You can see the path specification of the YLC5 data in this tab.

If you want to use the valuated YLC5 data (Masterpiece) also for
differing yarns, enter the deviation of the yarn elongation in percentage
in the "Yarn correction" cell.

Changing the minimum width.

Change the minimum width only if the error message "YLC: deviation
from set value of measuring wheel x too large" is displayed.

Enter the change in the "Minimum width" line.

Value range: - 2 E…0…+ 2 E (E = Number of needles per inch = Gauge
of the machine)

Example for E16: -32…0…+32 needles

: Afterwards you need to knit the original piece again.
Further information:

Helpers for Input [-> 275]

File tools [-> 281]

Table Tools [-> 280]

Setup Data [-> 267]

Overview of the Setup2 Editor of the CMS [-> 273]

Comparing Setup1 to Setup2 [-> 269]