Stoll CMS 730 S, Operating Instructions Manual

Page: 352 / 468

Repairing the knitting machine
7
Replacing parts 7.3
348
7.3.7 Removing and mounting carriage part
Removing carriage part The carriage part is removed when:

the cams must be replaced (e.g. wide or narrow coupling of tandem
machines)

if a carriage part is blocked, it is separated (separating point) with the
integrated device
The carriage assembly is stopped (support surface) outside the needle bed
and the carriage part is lowered again.
On tandem machines both front or rear carriage parts are raised, even
when only one is blocked.
This chapter contains information on:

Remove the carriage part to replace the cams [-> 348]

Remove the carriage part when the carriage assembly is blocked in the
needle bed [-> 350]

Assembling carriage part and carriage assembly [-> 353]
Remove the carriage part to
replace the cams
1. If a central lubrication is present, swivel it into mounting position.
2. Move the carriage assembly outward up to the support surface.
3. Switch off 40 V power supply.

Cover of carriage assembly
4. Remove the carriage assembly cover (1).
5. If the rear carriage part is removed, the needle detector is to be
removed as well.

Needle detector
6. Mark the position of the needle detector so that it can be reassembled
in the same position.