Stoll CMS 730 S, Operating Instructions Manual

Page: 208 / 468

Adjusting knitting machine
4
Advanced adjustments 4.2
204
4.2.22 Intarsia yarn carrier - check the pressure plates *
Turning over or replacing the
small pressure plates
(intarsia yarn carrier type 1)
1. Dismantle yarn carrier.

Dismantling of small pressure plate
2. Loosen but do not remove the screws (1).
3. Lift the clamping lever (2)out of the locating screw (3) and remove it.
When doing this, make sure that the spring pin (5) remains in the
housing (4).
4. Check whether the thickness designation 2.04 or 2.06 is visible on the
built-in pressure plate.
5. Remove the pressure plate from the clamping lever.
6. If the marking 2.04 or 2.06 was visible on the built-in pressure plate, turn
over the pressure plate and reinsert it.
- or -
➜
If the marking 2.04 or 2.06 was not visible on the built-in pressure plate,
insert a new pressure plate of the same thickness with the marking
facing upward.
7. Press the spring pin (5) into the spring part (4) and insert the clamping
lever (2).
8. Tighten the screws (1).
9. Make sure that the lifter (6) moves smoothly.
Further information:

Replacing yarn carrier [-> 362]

Symbols in this document [-> 12]
CAUTION
Complicated adjustment work is required when
replacing the pressure plates!
If the various thicknesses and positions of the pressure
plates are interchanged, complicated adjustment work is
required to set the stopping point of the yarn carrier correctly.
➜
Do not interchange the various thicknesses and positions
of the pressure plates!