Rohde & Schwarz SMM100A, User Manual

Page: 156 / 1088

Configuring the internal baseband source
R&S
®
SMM100A
156 User Manual 1179.1341.02 ─ 05
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CLOCk
on page 812
RF Power Ramping with Burst Marker
Option: R&S SMM-K22
If activated, the burst gate marker signal included in the ARB waveform file is used as
marker signal for the pulse modulator.
If this parameter is activated, but the loaded ARB waveform does not contain control
list or the burst gate marker is not defined, the ARB generator cannot be activated. An
error message indicates this situation, too.
You can create the suitable waveform files including the required burst gate marker sig-
nals, for example, with the R&S Pulse Sequencer software.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:PRAMp[:STATe]
on page 805
Create Multi Segment
Accesses the dialog for creating multi-segment waveforms (see Chapter 4.9, "Generat-
ing multi-segment waveform files" , on page 200).
Create Multi Carrier
Accesses the dialog for creating multi-carrier waveforms (see Chapter 4.10, "Generat-
ing multi-carrier signals" , on page 230).
Test Signal Form
Selects the form of the test signal. A choice between a sinusoidal, rectangular, AWGN
or test signal with constant I/Q is provided.
To access further settings, select Create Test Signal .
Remote command:
[:SOURce<hw>]:BB:ARBitrary:SIGNal:TYPE
on page 806
Create Test Signal
Opens the dialog with further setting for the selected Test Signal Form , see:
●
Chapter 4.6.3.2, "Sine test signals" , on page 157
●
Chapter 4.6.3.3, "Rectangular test signal" , on page 158
●
Chapter 4.6.3.4, "Constant IQ test signal" , on page 159
●
Chapter 4.7.4, "AWGN test signal" , on page 198
Using the arbitrary waveform generator (ARB)