Rohde & Schwarz SMM100A, User Manual

Page: 158 / 1088

Configuring the internal baseband source
R&S
®
SMM100A
158 User Manual 1179.1341.02 ─ 05
Phase Offset Q
Enters the phase offset of the sine-wave signal on the Q channel relative to the sine-
wave signal on the I channel.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe
on page 807
Generate Signal File
Generates a signal and saves it as a waveform file on the hard disk. Use the standard
"File Select" function to save the file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed
on page 808
Generate Signal RAM
Generates a signal and uses this signal as output straight away. The instrument saves
the file using a predefined filename.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate
on page 808
4.6.3.3 Rectangular test signal
Access:
1. Select "Baseband > ARB > General > Test Signal Form > Rect".
2. Select "Create Test Signal".
This dialog provides settings for configuration of a rectangular test signal. A rectan-
gular test signal with a duty factor of 0.5 is created. Amplitude and offset are
adjustable. Both paths, I and Q, use the same signal.
For more information, refer to
Chapter 4.6.2.2, "ARB test signals" , on page 149.
Settings:
Frequency ................................................................................................................... 159
Samples per Period .....................................................................................................159
Amplitude .................................................................................................................... 159
Using the arbitrary waveform generator (ARB)