Remote control commands
R&S
®
SMM100A
986
User Manual 1179.1341.02 ─ 05
Value ranges
●
Queries return the current value of the respective register, which permits a check of
the device status.
Return values: A decimal value in the range 0 to 32767 (=2
15
-1)
●
The configuration commands set the respective register thus determining which
status changes of the R&S
SMM100A cause the status registers to be changed.
Setting values: A decimal value in the range 0 to 32767 (=2
15
-1)
..................................................................................... 986
...........................................................................................986
...........................................................................................987
.................................................................................... 987
.....................................................................................987
:STATus:QUEStionable:CONDition
.................................................................................. 988
.......................................................................................988
...................................................................................... 988
:STATus:QUEStionable:NTRansition
................................................................................ 988
:STATus:QUEStionable:PTRansition
................................................................................ 989
................................................................................................989
:STATus:OPERation:CONDition?
Quieries the content of the CONDition part of the STATus:OPERation register.
This part contains information on the action currently being performed in the instru-
ment. The content is not deleted after being read out because it indicates the current
hardware status.
Return values:
<Condition>
string
Example:
:STATus:OPERation:CONDition?
Usage:
Query only
:STATus:OPERation:ENABle
<Enable>
Sets the bits of the ENABle part of the STATus:OPERation register. This setting deter-
mines which events of the Status-Event part are forwarded to the sum bit in the status
byte. These events can be used for a service request.
Parameters:
<Enable>
string
Example:
:STAT:OPER:ENAB 32767
all events are forwarded to the sum bit of the status byte.
STATus subsystem