Rohde & Schwarz SMM100A, User Manual

Page: 1027 / 1088

Maintenance, storage and disposal
R&S
®
SMM100A
1027 User Manual 1179.1341.02 ─ 05
The remote command required to start the test is described in Chapter 13.19, "TEST
subsystem" , on page 989.
Execute Baseband Selftest
Performs a baseband selftest.
The result (succeeded or failed) is displayed in the status field on the right.
Remote command:
:TEST:BASeband?
on page 990
Log Message
Displays the log message reported during the baseband test.
Remote command:
:TEST:BASeband:LOG?
on page 990
16.3.4.3 Selftest test generator settings (DAC)
Access:
1. This function is password-protected. Unlock the protection level 1 to access it.
2. Select "System Config > Setup > Maintenance > Selftest > DAC".
The "DAC" dialog contains the parameters for testing the IQ signal source.
The remote commands required to define these settings are described in Chap-
ter 13.19, "TEST subsystem" , on page 989.
State ..........................................................................................................................1027
IQ Source .................................................................................................................. 1028
Gain ...........................................................................................................................1028
Frequency ................................................................................................................. 1028
Select ARB File ......................................................................................................... 1028
State
Starts the test generator.
Remote command:
:TEST:BB:GENerator:STATe
on page 993
Performing maintenance tasks