Remote control commands
R&S
®
SMM100A
659
User Manual 1179.1341.02 ─ 05
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
).
Usage:
Event
13.4
Preset commands
The preset commands are not bundled in one subsystem. Therefore, they are listed
separately in this section.
In addition, a specific preset command is provided for each digital standard. These
specific commands are described in the associated subsystems.
Four presetting actions are available:
●
Activating the default state of all internal instrument functions (
Functions that concern the integration of the instrument into a measurement setup
are not changed, e.g. reference oscillator source settings.
●
Activating the preset state of the parameters related to the selected signal path (
●
Activating the preset state of all parameters that are not related to the signal path
(
●
Activating the original state of delivery (factory reset,
on page 660). Only functions that are protected by a password remain unchanged
as well as the passwords themselves.
When resetting, the following deviation between remote and manual control exists:
In contrast to the [Preset] key, the SCPI commands
and
not close open dialogs in the GUI.
:DEVice:PRESet
Presets all parameters which are not related to the signal path, including the LF gener-
ator.
Example:
DEV:PRES
Presets all instruments settings that are not related to the signal
path.
Usage:
Event
Preset commands
