Network operation and remote control
R&S
®
SMM100A
595
User Manual 1179.1341.02 ─ 05
Bit No.
Meaning
5
Command Error
This bit is set if a command is received, which is undefined or syntactically incorrect. An error
message with a number between -100 and -200, which denotes the error in greater detail, is
entered into the error queue.
6
User Request
This bit is set when the instrument is switched over to manual control.
7
Power On (supply voltage on)
This bit is set on switching on the instrument.
12.4.5
Questionable status register (STATus:QUEStionable)
This register contains information on questionable instrument states. Such states may
occur when the instrument is not operated in compliance with its specifications.
To read the register, use the query commands
or
.
Table 12-5: Meaning of the bits used in the questionable status register
Bit No.
Meaning
0–15
Not used
12.4.6
Operation status register (STATus:OPERation)
This condition part contains information on the actions currently being performed by
the instrument, while the event part contains information on the actions performed by
the instrument since the last readout of the register.
To read the register, use the query commands
or
.
Table 12-6: Meaning of the bits used in the operation status register
Bit No.
Meaning
0
Calibrating
The bit is set during the calibration phase.
1–2
Not used
3
4–15
Not used
12.4.7
Application of the status reporting system
The purpose of the status reporting system is to monitor the status of one or several
devices in a measuring system. To do this and react appropriately, the controller must
Status reporting system