Rohde & Schwarz SMM100A, User Manual

Page: 373 / 1088

Configuring the RF signal
R&S
®
SMM100A
373 User Manual 1179.1341.02 ─ 05
Pulse Delay
Sets the pulse delay. The pulse delay determines the time that elapses after a trigger
event before pulse modulation starts. The pulse delay is not effective for double pulse
generation.
Remote command:
[:SOURce<hw>]:PULM:DELay
on page 764
Double Pulse Delay
Sets the delay from the start of the first pulse to the start of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:DELay
on page 765
Pulse Output State
Activates the output of the pulse modulation signal.
Remote command:
[:SOURce<hw>]:PGENerator:OUTPut[:STATe]
on page 932
Pulse Output Polarity
Sets the polarity of the pulse output signal.
Remote command:
[:SOURce<hw>]:PGENerator:OUTPut:POLarity
on page 932
Set Global Connector for Pulse Modulation
Routes the pulse input signal by default to the global user connector Pulse Ext4
("Pulse In A"), and correspondingly the pulse output signal to Pulse Video5 ("Pulse Out
A").
See also Table 11-1 in Chapter 11.2.2, "About local and global connectors" ,
on page 528.
7.11.4.4 Pulse graph
Access:
► Select "RF" > "Analog Modulation" > "Pulse Modualtion > Pulse Graph".
The pulse graph is the graphical representation of the current pulse signal.
Analog modulations