RKC INSTRUMENT Z-TIO-G, Instruction Manual

Page: 193 / 246

9. COMMUNICATION DATA DESCRIPTION
IMS01T28-E4
9-85
 Operation flow (common procedure for SV select function operation)
1. Set SV select function
operation
2. Set the Master
channel module
address
3. Select the Master
channel
Set the function that you wish to have operate in the slave channel of the Z-TIO module
(P. 9-83).
In the slave channel, set the module address number of the module that includes the
channel to be specified as the master.
Remote SV function master channel module address (P. 9-87):

1 (Master channel is selected from itself)
0 to 99 (Master channel is selected from other modules)
In the slave channel, select the channel number that will be the master in the master
channel module. This setting is not required in the master channel.
Remote SV function master channel selection (P. 9-88): 1 to 99
4. Remote/Local
transfer
Change the slave channel to Remote mode (P. 9-16).
5. Control start
6. Adjust the RS bias
Perform adjustment after the start of control (P. 9-86) by setting
the bias, digital filter, and ratio at each slave with respect to the set
input from the master. Set these according to the actual operation
state.
7. Adjust the
RS digital filter
8. Adjust the RS ratio
When the controller selected as the master was placed into
the Remote mode, the RS bias (P. 9-30), RS digital filter
(P. 9-31), and RS ratio (P. 9-31) can be set.
Data on RS bias, RS ratio and RS digital filter is that in
cascade control or ratio setting.