RKC INSTRUMENT Z-TIO-G, Instruction Manual, Page: 18 / 246

2. SETTING PROCEDURE TO OPERATION
2-2
IMS01T28-E4
2.1 When Use Host Communication
Conduct necessary setting before operation according to the procedure described below.
To perform Host communication, a communication program must be created. Refer to
the RKC communication protocol or the Modbus communication protocol to create a
communication program.
[Communication support tool]
PROTEM2: Communication tool for SRZ
The PROTEM2 can be downloaded from the RKC official website:
https://www.rkcinst.com/.
For the communication protocol, refer to 6. RKC COMMUNICATION (P. 6-1)
or 7. MODBUS (P. 7-1) .
Set the Z-TIO-G module address.
Refer to 3.1 Module Address Setting (P. 3-2) .
Set the communication settings of Z-TIO-G module by the DIP switch.
For the DIP switch setting, refer to 3.2 Protocol Selections and Communication
Speed Setting (P. 3-4) .
Mount the Z-TIO-G module or SRZ unit on the DIN rail or panel.
Refer to 4. MOUNTING (P. 4-1) .
Wire the power supply and input/output.
Refer to 5. WIRING (P. 5-1) .
Connect host computer to the Z-TIO-G module or SRZ unit.
Refer to 5. WIRING (P. 5-1) .
Preparation of Host
communication program
Communication setting
Mounting
A
Module address setting
Wiring
Connection of
the communication line