RKC INSTRUMENT Z-TIO-G, Instruction Manual, Page: 80 / 246

7. MODBUS
IMS01T28-E4
7-16
[Example] When performing control by calling up data in Memory area 3 of CH1
1. The Memory area number, “3” is written to the Memory area transfer (006EH).
Data in Memory area 3 is called up to the CH1 register addresses.
CH1 register addresses
Memory area transfer 006EH 3 Memory area number, “3”
Event 1 set value (EV1) 0076H
Event 2 set value (EV2) 007AH
Event 3 set value (EV3) 007EH
Event 4 set value (EV4) 0082H
Control loop break alarm (LBA) time 0086H
LBA deadband 008AH
Set value (SV) 008EH
Proportional band 0092H The data of memory area 3 is loaded into these register addresses
Integral time 0096H
Derivative time 009AH
Control response parameter 009EH
Manual reset 00B2H
Setting change rate limiter (up) 00B6H
Setting change rate limiter (down) 00BAH
Area soak time 00BEH
Link area number 00C2H
2. Control of CH1 is performed by using data in the register addresses.
If the Memory area transfer (006EH and 006FH) and the Setting memory area number (0500H
and 0501H) are set to the same Memory area number, the respective data can be synchronized.

Values in the Control areas (0076H to 00C3H) become the same as those in the memory areas
(0504H to 0551H).

If data in the Control area is changed, data in the memory area is also changed.

If data in the memory area is changed, data in the Control area is also changed.