RKC INSTRUMENT Z-TIO-G, Instruction Manual, Page: 24 / 246

3. COMMUNICATION SETTINGS
3-2
IMS01T28-E4
3.1 Module Address Setting
Set communication setting before mounting and wiring of the Z-TIO module.
Do not separate the module mainframe from the base with the power turned on. If so,
instrument failure may result.
 Address setting switches
Set an address for the module using a small blade screwdriver.
When using two or more modules, set the desired address to each module.
To avoid problems or malfunction, do not duplicate an address on the same communication
line.
Address setting switch
Setting range: 0 to F [0 to 15: Decimal number]
Factory set value: 0
The module address number:
RKC
communication 0 to 15 (decimal)
Modbus 1 to 16 (decimal)
The value obtained by adding “1” to the set address corresponds to the address used
for the actual program.
Loader
communication 0
The module address of Z-TIO-G module is fixed to zero. The setting of address
setting switch is ignored.
 To prevent electric shock or instrument failure, always turn off the power
before setting the switch.
 To prevent electric shock or instrument failure, never touch any section other
than those instructed in this manual.
WARNING
!
CAUTION