Oki ES9160, Maintenance Manual

Page: 418 / 1087

ES9160 MFP / ES9170 MFP © 2012 OKI DATA CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 110
[LED 1] on the control panel will blink for a number of times that corresponds to the adjustment
value set for the equipment.
See the following table for the number of times [LED 1] blinks and its corresponding adjustment
value.
(6) Press [Button 1] to adjust the stapling position.
Every time [Button 1] is pressed, the alignment plate shifts 1 steps (0.4 mm) toward the “+”
direction.(The stacker [paper] moves upward and thus the stapling position moves downward
against the stapling mechanism.)
Adjustment range is from -7 to +7 steps. If [Button 1] is pressed when the alignment position is at
the “+7 steps”, the plate will return to the home position and then moves to the position of “-7
steps”.
(7) When the adjustment is completed, press [Button 2] on the finisher control panel to store the
adjustment value in memory.
When the value is stored normally, [LED 1] on the control panel will blink for a number of times
that corresponds to the adjustment value set for the equipment.
(8) Press [Button 1] and [Button 2].(Adjustment of LD and A3 paper finishes.)
(9) Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] again 3 times, and [Button 2] once again. (Adjustment of LG, B4, LT-R, A4-R and 8K paper
starts.)
[LED 1] on the touch panel blinks for the number of times corresponding to the current
adjustment value.
Perform adjustment for steps (6) to (8) in the same procedure.
(10) Turn OFF the power of the equipment.
(11) Turn OFF all bits of the SW1 on the Finisher control board.
(12) Install the board access cover.
Number of blinking Adjustment value
1 -7
2 -6
3 -5
4 -4
5 -3
6 -2
7 -1
8 0
9 +1
10 +2
11 +3
12 +4
13 +5
14 +6
15 +7