Oki ES9160, Maintenance Manual

Page: 314 / 1087

ES9160 MFP / ES9170 MFP © 2012 OKI DATA CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 6
6.3.2 Paper alignment at the registration roller
The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Sub-code
(*1) 0: Long size 1: Middle size 2: Short size
(*2) 0: Long size 1: Middle size 2: Short size 3: Post card
(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220-239 mm (8.7-12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
2. The adjustment of “Post card” is for Japan only.
<Procedure>
(1) Perform the test print according to the following procedure.
(3) Perform the same procedure for all paper sources.
Paper
type
Weight
Upper
drawer
Lower
drawer
PFP
upper
drawer
PFP lower
drawer
LCF ADU
Bypass
feed
Plain
paper
64 - 80 g/m
2
17 - 20 lb. Bond
4100 (*1) 4101 (*1) 4108(*1) 4109 (*1) 4111 4110
(*1)
4103
(*1)
Thick
paper 1
81 - 105g/m
2
21 - 28 lb. Bond
4115 (*1) 4116 (*1) 4117 (*1) 4118 (*1) 4119 4120
(*1)
4104
(*1)
Thick
paper 2
106 - 163g/m
2
29 lb. Bond - 90
lb. Index
- - - - - - 4105
(*1)
Thick
paper 3
164 - 209g/m
2
91 - 110 lb.
Index
- - - - - - 4106
(*2)
OHP - - - - - - - 4107
(*3)
(*4) 1: Single-sided grid pattern 3: Double-sided grid pattern
(2) Check if any transfer void is occurring. If
there is a transfer problem, try the values in
descending order as “31”
“30” “29”···
until the transfer void disappears. At the
same time, confirm if any paper jam occurs.
Also, when the aligning amount has been
increased, this may increase the scraping
noise caused by the paper and the film sheet
as it is transported by the registration roller. If
this scraping noise is annoying, try to
decrease the value.
Fig.6-8
(Code) [START] (Sub-code) [START]
[0][5]
[Power]
Current value
displayed
Enter new
value
[POWER]
OFF/ON
(Exit)
[Drawer
selection]
(*4) +[FAX]
(Test print)
[OK] or
[INTERRUPT]
Stores in memory
(Not necessary for LCF)
50mm - 100mm
Transfer void