Oki ES9160, Maintenance Manual

Page: 778 / 1087

ES9160 MFP / ES9170 MFP © 2012 OKI DATA CORPORATION All rights reserved
REPLACEMANT OF HDD/PC BOARDS
9 - 14
9.2.4 Precautions and Procedures when replacing the SYS board
Notes:
Since the data to be used in other models are included in the SYS board, rewrite them as new
data by means of the following procedure.
A procedure for SYS board replacement is shown below.
Fig. 9-16
Notes:
• "[C] Update system ROM version (Jig)" is required only for the equipment in which the ADI-
HDD has been installed and the OS version is less than "2000".
• "[E] Restore ADI key" is required only for the equipment in which the ADI-HDD has been
installed.
[A] Return License
Notes:
If the Setting Mode (08) is not started up, “[A] Return license” can be omitted.
In that case, since "[F] Reinstallation of License" cannot be performed, reinstall the license with
[ 1 ]Re-registration when the board is replaced.
(1) Start up with the Setting Mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [3840], and then press the [OK] button.
(4) Select the license to be returned, and then press the [REMOVE] button.
START
[A]
[E]
[B]
[C]
[D]
[F]
[H]
[G]
END
[D]
[I]
ADI-HDD SATA-HDD
SATA-HDD: Normal HDD
ADI-HDD: Securely HDD