Oki ES9160, Maintenance Manual

Page: 1013 / 1087

05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce
dure
Servic
e UI
08 Setting
mode Process Transfer 5076 1 Paper width transfer
output correction (C)
(Small) Refer to
content
s
0~255 M <Default value>
168 4
08 Setting
mode Process Transfer 5076 2 Paper width transfer
output correction (L)
(Small) Refer to
content
s
0~255 M <Default value>
177 4
08 Setting
mode Process Process 5101 Toner cartridge
correction table
switching 0 0~2 M Corrects the image density according to the detection
value of the sensor. Changing this code varies the
correction amount of the image density. Set this code
when the density is too high or low.
0: Middle-level correction 1: Low-level correction 2:
High-level correction It is hardly corrected at the normal
temperature and humidity. 1
08 Setting
mode Process Developm
ent Toner near empty 5155 Toner near empty
threshold setting 1 0-3 M Sets the timing for when the toner near empty display
appears. The larger the value, the later the display
appears.
0: Longer *1
1: Center (normal)
2: Shorter *2
3: No detection
*1: The period of time (number of counts) from the
appearance of the near empty display to actually
running out of toner is longer (larger) than that of
"center".
*2: The period of time (number of counts) from the
appearance of the near empty display to actually
running out of toner is shorter (smaller) than that of
"center". 1 Yes
08 Setting
mode Process Fuser Fusing correction
control time
immediately after
warming-up 5210 0 Temperature
correction 2 0~10 M 0: Disabled, 1: 1 minute, 2: 2 minutes, 3: 3 minutes, 4: 4
minutes, 5: 5 minutes, 6: 6 minutes, 7: 7minutes, 8: 8
minutes, 9: 10 minutes, 10: 15 minutes 4
08 Setting
mode Process Fuser Fusing correction
control time
immediately after
warming-up 5210 1 Maximum time of
lamp ON 2 0~10 M 0: Disabled, 1: 1 minute, 2: 2 minutes, 3: 3 minutes, 4: 4
minutes, 5: 5 minutes, 6: 6 minutes, 7: 7minutes, 8: 8
minutes, 9: 10 minutes, 10: 15 minutes 4
08 Setting
mode Process Fuser 5285 Fusing temperature
during printing (Plain
paper/Sub) Refer to
content
s
0 to 14 M 0: 140°C 1: 145°C 2: 150°C 3: 155°C 4: 160°C 5: 165°C
6: 170°C 7: 175°C 8: 180°C 9: 185°C 10: 190°C 11:
195°C 12: 200°C 13: 205°C 14: 210°C
<Default value>
9 1
36