Oki ES9160, Maintenance Manual

Page: 1051 / 1087

05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce
dure
Servic
e UI
08 Setting
mode System User
interface 9012 Language displayed
at power-ON Refer to
content
s
- SYS <Default value>
English
11
08 Setting
mode System User
interface 9016 Counter installed
externally 0 0~3 M 0: No external counter
1: Coin controller
2: Copy key card(This value is valid only when “2” is set
to 08-201.)
3: Key copy counter 1
08 Setting
mode System Counter 9017 Setting for counter
installed externally 1 0-1, 4-5 M Selects the job to count up for the external counter.
0: Not selected
1: Copier
4: Printer
5: Copier/Printer 1
08 Setting
mode System General 9022 Easy setup production
process flag 99 0~99 SYS Perform this code when an error occurs during the easy
setup (unpacking manual adjustment) and you want to
finish the easy setup, or when the error is canceled and
you want to restart the unpacking manual adjustment.
0: Packing mode finished (before unpacking is started)
1: Auto-toner adjustment finished (The message
prompting the
installation of the toner cartridge is displayed.)
2: Toner cartridge is installed 99: All the unpacking
adjustments
finished
Only 0 to 2 and 99 are available for this code.
1
08 Setting
mode System General 9023 Trial period setting 254 1~60 SYS Sets the trial period from 1 to 60 days. This setting is
effective only when the default value is "254". Once the
default value is set, this value is only used for a
reference.
1 Yes
08 Setting
mode System General 9025 Notifying condition of
trial period end 3 0~255 SYS Sets when the end of trial period is notified.0: On the
day it ends 1 to 255: n days before
1 Yes
08 Setting
mode System General 9026 Notifying address of
trial period end 3 0~3 SYS Sets where the end of the trial period is to be notified. 0:
OFF 1: User 2: Service center 3: User and service
center
1 Yes
08 Setting
mode System General 9027 Forcible end of trial
period - - SYS [CANCEL]: Cancel
[INITIALIZE]: Forcible end
When the “Forcible end of trial period” is performed, “0”
is set in the code (08-9023) to end up the trial period
forcibly.
3 Yes
08 Setting
mode System Initializatio
n 9030 Initialization after
software version up - - SYS Perform this code when the software in this equipment
has been upgraded.
3 Yes
08 Setting
mode System User
interface Counter installed
externally 9037 Job handling-short
paid-coin controller 1 0~1 SYS Sets whether pause or stop the printing job when it is
short paid using a coin controller.0: Pause the job 1:
Stop the job
1 Yes
74