Oki ES9160, Maintenance Manual

Page: 847 / 1087

11
© 2012 OKI DATA CORPORATION All rights reserved ES9160 MFP / ES9170 MFP
FIRMWARE UPDATING
11 - 15
(9) Press the [ON/OFF] button to shut down the equipment, and then remove the USB media.
Notes:
When the equipment has been shut down normally, the LCD screen and LEDs (green and red)
go OFF. When OS data have been updated and the equipment has been shut down immediately after the
update, the LEDs (green and red) may not go OFF even if the LCD screen goes OFF. This indicates that the
equipment is not shut down normally. Press the [ON/OFF] button on the control
panel for more than 5 seconds, and then turn the main power switch OFF. Then remove the USB media.
(10) Perform the initialization of the updating data.
• Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.
• Key in “9030”, and then press the [START] button.
• Press the [INITIALIZE] button.
[B] Confirmation of the updated data
After the updating is completed, check each data version in the Setting Mode (08) to confirm that the
data were overwritten properly.
P. 11-72 "11.6 Confirmation of the updated data"
RADF update Error
Error number Error message Error content
R01
Time out
(When the download is requested) Communication timeout
(When the download is requested)
R02
Time out
(When the download is written) Communication timeout
(When the download is written)
R03
Time out
(When the download is finished) Communication timeout
(When the download is finished)
R05
Deletion error
(When the download is written) Deletion error
(When the download is written)
R06
Writing error
(When the download is written) Writing error
(When the download is written)
R08
Reception status code abnormality
(When the download is requested) Reception status code abnormality
(When the download is requested)
R09
Reception status code abnormality
(When the download is written) Reception status code abnormality
(When the download is written)
R10
Reception status code abnormality
(When the download is finished) Reception status code abnormality
(When the download is finished)
R21
RADF Uninstallation RADF not installed
R23
RADF Firmware model mismatch RADF ROM for different model
data connected
R00 Other error Other error