Mindray Passport 5-Lead, Service Manual

Page: 161 / 544

Passport 5-Lead, 5L, LT, XG Service Manual 0070-00-0420 1 - 149
Operation (5-Lead, 5L, LT and XG) Operation (XG)
7. The message “Calibration Complete” will appear when all the channel(s) have been
successfully calibrated. Any channel that has been adjusted will display “Adj”.
FIGURE 1-82 Calibration Completed
NOTE: If any channel cannot be calibrated due to a sampling error,
the “Sampling Error” message will appear under the
“Continue?” message and “ERR” will be displayed next to
any channels with a sampling error. Pressing select will
calibrate only those channels that do not have a sampling
error.
If any channel fails calibration, the gas value will be “XXX”. These channels will appear as
“XXX” in the normal run mode as well. Repeat procedure from step 1. If problems persist, call
for service.
1.6.15 Alarms
The Datascope Passport XG Monitor provides high and low alarm limits for heart rate (HR),
systolic pressure (IBP1/NIBP Sys), diastolic pressure (IBP1/NIBP Dia), mean pressure (IBP2
Mean), respiration rate, ETCO
2
, and SpO
2
. An alarm for apnea is also provided. If the
optional Gas Module is installed, a second and third page of alarm limits is added.
1.6.15.1 Setting Parameter Alarm Limits
1. To access the Alarms Limits menu press the Alarms Limits key (17).
2. Using the UP
q
and DOWN
p
arrow keys (1) and SELECT (2) keys, (see “Use of
Menus” on page 1-109) set parameter limits as desired.
3.
Press the limits key again to access further alarm parameters (when the Gas Module is
installed) or press the exit key to return to the main menu.
FIGURE 1-83 Alarm Menu
CALIBRATION DATA
CO2: 5.0% ADJ
O2: 33% ADJ
N2O: 55% ADJ
DES: 2.0% ADJ
Calibration Complete
EXIT = Quit
ALARMS
VOLUME
LIMITS
MUTE
Depress the Alarms
Limits Key to access
the Alarms Menu