Mindray Passport 5-Lead, Service Manual

Page: 291 / 544

Passport 5-Lead, 5L, LT, XG Service Manual 0070-00-0420 4 - 11
Repair Information Mounting Instructions
4.6 Mounting Instructions
4.6.1 Rolling Stand Assembly Instructions
(See Figure 4-1 )
1.
Press the steel column firmly into the base.
2.
Lock the column into the base by screwing supplied bolt through the supplied lock
washer, large flat washer, and base into bottom of column.
3. Remove the column screw from the top of the column. Insert the swivel head on top of
the column and replace the column screw.
4.
Use clamp to secure basket to rolling stand column.
4.6.2 Bedrail Hook Mount
(See Figure 4-2 )
1. Secure the hook mount (P/N 0436-00-0062) to the rear of the Passport using four #8-
32 x .38 flat head screws (P/N 0212-14-806).
2.
Place the Passport over any bedrail with a diameter of less than 1.25".
4.6.3 Bed Mount
(See Figure 4-3 )
1.
Secure the mounting plate (P/N 0386-00-0156) to the rear of the Passport using four
#8-32 x .38 flat head screws (P/N 0212-14-0806).
2. Place the two lower clamps (P/N 0343-00-0064) into the slots at the bottom of the bed
mount (P/N 0997-00-0297) and secure using the two knobs (P/N 0366-00-0080).
3.
Place bed mount over lower bedrail and secure in place by positioning the lower clamps
against bedrail and tightening the two knobs.
4.6.4 Passport Mounting - Rolling Stand/Wall Mount
(See Figure 4-4 )
1.
Secure the mounting plate (P/N 0386-00-0156) to the rear of the Passport using four
#8-32 x .38 flat head screws (P/N 0212-14-0806).
2. While pulling down on the spring lock, slide the holding bracket into the swivel head of
the rolling stand or the wall mount.
3.
Place the Passport into the slots in front holding bracket.
4.6.5 Power Supply Mounting
(See Figure 4-5 )
1.
Secure the Mounting Plate (P/N 0386-00-0156) to the power supply bracket (P/N
0406-00-0544) using the four #8-32 x .38 flat head screws (P/N 0212-14-0806).