Mindray Passport 5-Lead, Service Manual

Page: 538 / 544

Perform Verification and NIBP Calibration - Annually Preventive Maintenance
8 - 2 0070-00-0420 Passport 5-Lead, 5L, LT, XG Service Manual
8.4 Perform Verification and NIBP Calibration - Annually
1.
Perform test as outlined in “Power-Up Verification” on page 7-20 through “Cosmetic
Checks” on page 7-32.
2. Perform NIBP calibration as described in “Diagnostics and Calibration Procedure” on
page 7-5.
8.5 Perform Verification and CO
2
Pump Calibration -
Annually
Perform test as outlined in “Sidestream CO
2
Pump Verification / Calibration Procedure” on
page 7-27.
8.6 User Preventive Maintenance Introduction
This section of the manual outlines routine maintenance that should be performed by the user.
The Passport XG Monitor is designed for stable operation over long periods of time and
under normal circumstances should not require technical maintenance beyond that described
in this section. However, it is recommended that routine maintenance calibration and safety
checks be performed at least once a year, or more often as required by local statutory or
hospital administration practice.
8.6.1 Care and Cleaning of Monitor
The monitor enclosure may be cleaned with a mild soap and water solution or ammoniated
window cleaner. Apply cleaning solution to the cloth, not directly onto the monitor. DO NOT
apply large amounts of liquid. DO NOT use abrasive cleaning agents or organic solvents.
WARNING: Do not clean the monitor while it is on and/or plugged in.
To prevent scratches on the front panel display screens, blow or carefully brush dust and dirt
particles with a soft sponge moistened with cleaner solution; or a fine, soft-hair brush. DO
NOT use abrasive cleaning materials. Fingerprints and stains may be removed by using a
liquid lens cleaner and a soft cloth. DO NOT wipe a dry screen or use alcohol or chlorinated
hydrocarbon solvents.
8.6.2 Care and Cleaning of Datascope Flexisensors and Datasensors
NOTE: If your unit is equipped with Nellcor* SpO2 or Masimo*
SpO2, refer to sections 1.3.9 (Nellcor) or 1.3.10 (Masimo)
and/or the individual instruction sheets that are packaged
with each sensor.
* This feature applicable only if available / installed in your unit.