Quick Setup
12/121
Operating Manual dryve D1, ST-, DC-, EC/BLDC-Motor Control System - V2.4
A first test run can be carried out to
test the wiring.
1.
In the drop-down menu, select the "Binary" travel profile.
2.
Use the "clockwise" and "counter-clockwise" buttons
under the table to move the motor.
4.
Check to make sure that the "Clockwise" button
moves the motor shaft clockwise. If this
is not the case, disconnect the power supply and
check the wiring.
Now, an example of parameterisation can be carried out.
5.
Using the buttons, move the carriage or rotation arm manually
to the middle of the distance available for travel.
6.
Create the motion sequence shown in the table.
7.
Select Row 1 by clicking in the number field of the row.
8.
Start the program with the "Start" button.
The program can be stopped with the "Stop" button. If the program were to be started again,
it would continue from the marked row.
For igus
®
motors, the motor controller data have been set appropriately by default.
For user-defined motors, the controllers must be parameterised.
Use the help notes provided in the manual.
Congratulations!
You are now familiar with the basic functions of the dryve D1.
