FISCHER FISCHERSCOPE X-RAY XDLM 231, Operator'S Manual

Page: 77 / 236

Variables Available for Block Evaluation Setting Up the Print Form Using PDM
FISCHERSCOPE
®
X-RAY 75
@DATCurrent date for the print form
Default format: DD/MM/YYYY, e.g., 24.05.1998)
@DF1Density of the coating that has been entered into the current
product. This applies only to coatings with a fixed
composition.
@DIRName of the directory (folder),
where the current product is saved.
@DM1Unit of measurement (e.g., μ m, mils or %) of the respective
quantity to be measured
@FISInserts the header with the instrument name into the
print form.
Note: If this variable is not used in the print form template
it will automatically be placed at the beginning of the
the print form template, when saving.
The header will then appear at the beginning of the print
form; i.e., the header cannot be deactivated!
Regarding the numerals
1; 2; 3 … after certain
variables:
A measurement consists
of one or more single
readings (“channels”) that
are identified by consecu-
tive numbers (1,2,3).
Example “Dual coating
measurement”
Top coating thickness = 1
Intermediate coating
thickness = 2
@MA1Largest single reading in the block = Maximum
@MABName of the measurement application that the current
product accesses.
@MI1Smallest single reading in the block = Minimum
@MNRNumber of the measurement application that the current
product accesses.
@MW1Mean value of the single readings of the block.
@N<1Number of readings in the block that fall below a
preset lower specification limit (LSL) .
@N>1Number of readings in the block that exceed a
preset upper specification limit (USL)