FISCHER FISCHERSCOPE X-RAY XDLM 231, Operator'S Manual

Page: 142 / 236

140 FISCHERSCOPE ® X-RAY
Programming Coordinates for Automatic Measurements (XDLM 237)
Procedure
1. From the programming field select the options Pattern .
The following Figure shows a section of the window for coordinates programming.
2. Click in the right side of the lower table field.
3. The lower table field is now highlighted in yellow. The coordinates of the individual points are
displayed in this window. Each individual point is the starting point of each pattern.
1. On the first part, travel to the first individual point: In the video image, use the mouse to click
the desired location or use the joystick at the front of the instrument.
1. Click Store .
The coordinates of the individual point are displayed in the lower table field.
2. Click in the right side of the upper table field.
The upper table field is now highlighted in yellow. The relative coordinates of the pattern, which
are then arranged around the respective point, are stored there.
The first point is already entered into the table as X=0 and Y=0. Thus, the first point of the
pattern is the respective reference point of the lower table.
3. Travel to the next measurement point of the pattern: In the video image, use the mouse to click
the desired location or use the joystick at the front of the instrument.
4. Click Store .
5. Repeat steps 3 and 4 for all measurement points of the pattern.
6. Click in the right side of the lower table field.
The lower table field is now highlighted in yellow.
7. Travel to the next individual point. In the video image, use the mouse to click the desired loca-
tion or use the joystick at the front of the instrument.
8. Click Store .
9. Repeat steps 7 and 8 for each individual point.
Pattern
Individual Points
Upper table field; the relative coordi-
nates of the points of the pattern are dis-
played here
Lower table field; the coordinates of the
individual points are displayed here