FISCHER FISCHERSCOPE X-RAY XDLM 231, Operator'S Manual

Page: 184 / 236

182 FISCHERSCOPE ® X-RAY
Pattern Recognition (XDLM 237)
19.To transfer the search images programmed for the first individual printed circuit board to the
other individual printed circuit boards, enter 10 in the Replay at Pos.No. field.
21.4.1 Automation of the measurement with a task
To avoid having to define the search images and search areas for all individual printed circuit
boards, you can automate the measurement with a task. In the following, a task is described that
executes the steps listed below:
1. Setting the first datum point (+1)
2. Setting the second datum point (+2)
3. Loop: Execute the following steps for each individual printed circuit board:
a Move to the next XY position
b Perform pattern recognition: For the first six XY positions, search image no. 1 (definition in
command f58) is used, and for the next four XY positions, search images 7 to 10 are used.
c Start a measurement
f42 Adjust Datum Point 1 ;Create message ... dialog
|f32 ;Set XY(Z)-offset (1.datum)
|f42 Adjust Datum Point 2 ;Create message ... dialog
|f29 ;Set XY(Z)-offset (2.datum)
|p51 LabelA ;Set label ... for GOTO
|f38 ;Test coordinates, no para = next pos., or use pos.no.#
|f58 1 ;Picture No. Patternrecognition
|f01 ;Start measurement
|f38 ;Test coordinates, no para = next pos., or use pos.no.#
|f58 1 ;Picture No. Patternrecognition
|f01 ;Start measurement
|f38 ;Test coordinates, no para = next pos., or use pos.no.#
|f58 1 ;Picture No. Patternrecognition
|f01 ;Start measurement
|f38 ;Test coordinates, no para = next pos., or use pos.no.#
|f58 1 ;Picture No. Patternrecognition
|f01 ;Start measurement
|f38 ;Test coordinates, no para = next pos., or use pos.no.#
|f58 1 ;Picture No. Patternrecognition
|f01 ;Start measurement
|f38 ;Test coordinates, no para = next pos., or use pos.no.#