Dynapac PL2000F, Instruction Manual

Page: 45 / 283

Machine description
34 4812313240.pdf
2017-12-1
machinist of the present operating modes as well
as any setting and maintenance work required on
the machine.
All machine settings, including the milling depth
and slope control, can be simply programmed
and modified by means of a perforated keypad
with internationally comprehensible symbols.
Space has been left for the installation of a
camera display for observing the planer track and
the dead space. This equipment is optionally
available and can be installed with four video
cameras.
The main control panel, the ground control panels
and access to all important switching and
connection points can be covered.
Ground control panels: The operating panels
housed here are located on both sides of the
planer, in front of and behind the milling drum box.
They contain duplicates of the main controls of the
operator’s control station with override functions
so that the milling process can be monitored,
corrected and interrupted from this point.
One digital controller for the milling depth and one
for the slope position are attached next to the rear
operating panels on the left and right sides.
Dynapac CAN-BUS data communication
system: The tried and tested state-of-the-art
electronic PLC (Programmable Logic Control)
monitors all control functions of the cold planer.
Signals processed by microprocessors are safely
transferred by an efficient CAN-BUS system (Data
Information System) and displayed as information
on the LC display. Possible function deviations