Dynapac PL2000F, Instruction Manual

Page: 248 / 283

Maintenance
237
4812313240.pdf
2017-12-1
Milling drum gear box
Oil level check
To check the oil level and while adding oil, the lock
screw for the oil check (1) must be in the 9 o’clock
position.
- Lower the machine on to the service
supports.
- Lift the side board and secure it.
- Ensure that the drive engine cannot be
started.
- Turn the milling drum until the mark (1) on the
drum is in the 9 o'clock position
- Remove the Allen screw (2) and the screw
protection (3).
- Remove the inspection screw.
The oil level should reach the lower edge of the
hole for the locking screw.
- Fill oil using the open filling screw until some
oil exits the hole of the locking screw.
- Properly reinstall the inspection screw,
screw protection (3) and Allen screw.
When adding oil, ensure cleanliness.
Fig. 1. Drum
2. Allen screw
3. Screw protection