Dynapac PL2000F, Instruction Manual

Page: 213 / 283

202
Maintenance schedule
4812313240.pdf
2017-12-1
Avoid electrical soldering work on the machine; this can lead to damage of the
electronic and hydraulic modules!
However, if exceptional electrical soldering work on the machine should
become necessary, the following is to be heeded before beginning work:
- the ignition is turned off
- the power circuit is interrupted
- the electrical devices are disconnected from the power supply
- the ground terminal of the solderer is placed as closely as possible to the
point to be soldered.
During all work on the electrical installation, always remove the mass cable
from the battery.
Only use fuse inserts of the stipulated amperage.
2 Liability exclusion in case of use of non-original spare or wear parts
as well as incorrect operating materials.
For maintenance and repair work, only the wear and spare parts allowed by
the manufacturer are permitted to be used and are to be installed by experts.
Consult the manufacturer in case of doubt.
Only those materials that are described in these operating instructions are to
be used as lubricating and operating materials.
In the case of non-compliance with these regulations, liability of the
manufacturer for resulting damage is excluded.
3 Maintenance intervals
The manufacturer is adding more and more maintenance-free modules to the
machine construction. The number of lubrication points described in the
following can therefore deviate from the number of lubrication points that
actually exist on the machine.
The maintenance intervals and the degree of maintenance for the drive engine
are not completely presented in the following. They are to be executed
according to the engine manufacturer following the enclosed operating and
maintenance instructions.