Dynapac PL2000F, Instruction Manual

Page: 262 / 283

Maintenance
251
4812313240.pdf
2017-12-1
Water pump – Check oil level
Check oil level, oil level should between Min.
and Max.
- If oil level lower than Min., please fill
specified oil.
- If oil level over Max., please drain some oil
out until the level keep between Min. and
Max. (Fill about 0.8kg).
Water pump – Drain oil
- Release the pressure from accumulator
(1).
- Unscrew the plug (2), and remove
accumulator.
- Unscrew the drain plug and drain oil from
water pump.
Be careful to handle the oil that drains
from water pump in case of adding
pollution to environment.
- Fill oil for water pump according to reverse
step of draining oil.
After filling oil, please run the pump for a
while and check again if oil is enough.
Fig. 1. Accumulator
2. Plug
1
2
Fig. Water pump