Dynapac PL2000F, Instruction Manual

Page: 144 / 283

Machine description
133
4812313240.pdf 2017-12-1
1
2
3
4
Fig. 1. Bolt
2. Detent bore
3. Handle
4. Interlock
Fig. Retaining hook
Interlock on scraper flap
One interlock for the scraper flap can be
found on either side of the back of the drum
box.
The interlock must be released before the
scraper flap can be opened.
When interlocked, the bolt (1) is in the detent
bore (2).
Unlocking procedure:
‐
Use handle (3) to rotate interlock bolt
upwards and slide towards the center of
the vehicle, via the sliding interlock (4).
‐
Rotate the bolt downwards so that the
handle lies on the inner side of the sliding
interlock (4).
Retaining hook of scraper flap
The retaining hook for the scraper flap can be
found on the right-hand side of the machine.
When the scraper flap is opened, this
automatically engages in the retaining hook.
The limit switch is also activated.
Only open the scraper flap once the
milling drum drive and the travel drive have
been switched off.
Refer to limit switch of scraper flap.
Unlocking procedure:
- Use the appropriate controls to open the
scraper flap so wide that the retaining
hook is disengaged.
- Swivel retaining hook upwards.
- Use appropriate controls to close the
scraper flap completely.