Dynapac PL2000F, Instruction Manual

Page: 230 / 283

Maintenance
219
4812313240.pdf
2017-12-1
Fuel filter water separator
Drain the water separator every day or when
engine electronics error messages appear.
Collect fuel-water mixture in a suitable container
and dispose of properly.
There is a drain valve (1) on the underside of the
filter cartridge.
Disconnect engine electrics plug (2) and screw on
drain valve (1) until the neck can be pulled out.
Drain off fluid until only clear fuel runs out.
Then slide the neck back again and close drain
valve until hand tight.
Follow Engine operating instructions!!
Air filter
The air filter can be found in the rear section of the
engine compartment and is accessible once the
engine hood has been opened.
In order to reach the filter element, the wing bolt
(2) must be loosened and the locking lid of the
filter casing removed.
After removal, replace the outer filter element by a
new one or clean it with compressed air.
The inner filter element must be replaced if it is
dirty. It cannot be cleaned.
Follow Engine operating instructions!!
Fig. Air filter