Dynapac PL2000F, Instruction Manual

Page: 231 / 283

220
Maintenance
4812313240.pdf
2017-12-1
Cooler
Check the coolant level daily before starting
work.
Replace the coolant at least once per year.
The filler neck of the coolant compensation tank
can be found behind the maintenance flap of the
operator’s control panel.
The system is under pressure when it is
hot. When it is opened, there is danger of
scalding!
Also check the radiators daily for dirt; if necessary,
clean with suitable methods.
Collect used coolant in a suitable container
and dispose of properly.
Follow engine operating instructions!!
Coolant filter
The coolant filter can be found in the rear section
of the engine compartment and is accessible once
the engine hood has been opened.
The system is under pressure when it is
hot. When it is opened, there is danger of
scalding! Let the engine cool before replacing
the filter.
Close the locking valve (1) of the coolant filter,
loosen the filter and clean the contact surface.
Slightly lubricate the seal of the new filter before
installing it. Tighten by hand. Open the locking
valve again.
After replacing the filter, keep an eye on the
seals.
Dispose of used filters properly.
Follow Engine operating instructions!!
Fig. Coolant filter
Fig. Cooler