Dynapac PL2000F, Instruction Manual

Page: 265 / 283

254
Maintenance
4812313240.pdf
2017-12-1
Compressed air system
Maintenance unit and compressed air system
A maintenance unit that separates the
water from the air and enriches the air- flow with a
fine oil mist, thus providing for a longer lifetime of
the parts, is located on the compressed air tank.
Check the filling level of the oiler (1) every 50
operating hours and replenish if necessary.
Drain any water that has formed into the water
separator (2).
Also drain any condensation that has formed in
the compressed air tank.
The compressed air tank and connected
maintenance unit can be found behind the storage
room flap on the left-hand side of the machine.
- Unscrew the oil reservoir (1) by hand and
replenish the stipulated oil up to the mark ”max“;
then properly screw the oil reservoir in again.
- Drain any water that has formed in the water
separator (2) by opening the valve (3); close the
valve again properly as soon as the water has
completely drained.
- Drain any water that has formed in the
compressed air tank by pulling the valve eyelet
(4). Drain water only when the drive engine is not
running. The escaping air drives the water from
the tank. Hold the valve open until no more water
exits.
Fig. 1. Oiler
2. Water separator
3. Valve
4. Valve eyelet
3
2
4
1