Dynapac PL2000F, Instruction Manual

Page: 236 / 283

Maintenance
225
4812313240.pdf
2017-12-1
High-pressure hydraulic filter
Replace filter cartridges once the maintenance
indicator (1) is red.
The filters should be checked 10 operating hours
after repairs on the hydraulic system and replaced if
necessary!
Always replace the filter elements in pairs!
The filter can be found in the rear section of the
engine compartment and are accessible once the
engine hood has been opened.
Loosen the filter pot with a hexagonal key and
unscrew it by hand.
After unscrewing the filter pot, empty the
separated dirt into a used oil container. Remove
the filter element and put it into a container for
recycling (danger of pollution!). Wash out the
casing, replace the O-rings and apply lubrication.
Screw the filter casing with the new filter element
back on and tighten securely.
The red mark on the maintenance indicator (1) is
reset automatically.
Wear protective clothing when working with hot
oil.
Danger to health if oil contacts skin.
Never clean a filter and then re-use it!
Always use new filters.
Fig. High-pressure hydraulic
filter
1. Indicator