Dynapac PL2000F, Instruction Manual

Page: 133 / 283

Machine description
122
4812313240.pdf
2017-12-1
Guardrail
There is one guardrail on both the left and
right between the ladders and operator’s
control stations.
The guardrails must be set up as required and
once the operator’s control station has been
entered.
Each of the guardrails consists of one outer
section (1) and two inner sections (2).
- Regarding the front guardrail, both outer
section and inner section can be adjusted;
regarding the rear guardrail, only the inner
section can be adjusted.
The diagram shown here indicates the
different situations in which the guardrail
should be set up.
- (A) Close guardrail
- (B) Open guardrail to enter and exit from
the operator’s control station.
- (C) Inner section of front guardrail fold out
– the operator stand out of the operator
platform when the platform is in the middle
position.
Danger of crushing! Do not reach into
the joint area during the folding process
as there is a risk that fingers and hands
will be crushed.
Fig. 1. Outer section
2. Inner section
(A)
(B)
(C)
2
1
2