Dynapac PL2000F, Instruction Manual

Page: 239 / 283

228
Maintenance
4812313240.pdf
2017-12-1
Oil cooler
The drainage point for the gear and engine oil is in
the rear section of the machine underside.
The stopcock (2) has three switch positions:
- Closed (2A)
- Drain for engine oil(2B)
- Drain for pump distribution transmission(2C)
Collect used oil in a suitable container and
dispose of properly.
- Unscrew seal cap (1) and open stopcock (2) in
position (2C). After draining, close the
stopcock in position (2A), fit the seal cap (1)
with a new seal and screw back on.
- Add new oil via the unscrewed filling screw.
Continue to do so until the oil level reaches
the bottom edge of the opening and some oil
runs out.
- Reseal inspection screw and oil fill screw
correctly.
Ensure cleanliness!
Check the oil lever again after running for
15 minutes, top up oil if necessary.
Wear protective clothing when working with
hot oil. Danger to health if oil contacts skin
Fig. 1. Seal cap
2. Stopcock