Dynapac PL2000F, Instruction Manual

Page: 252 / 283

Maintenance
241
4812313240.pdf
2017-12-1
Runners on the side boards
The runners of the side boards continuously slide
over the asphalt during milling operation and are
thus subjected to an elevated degree of wear. If the
material of the runner becomes too thin, it must be
replaced.
In the case of divided runners, the relevant element
is to be replaced.
Check the runners on both side boards
regularly and replace if necessary.
- Lower the machine on to the service supports.
- Lift the side board and secure it.
- Ensure that the drive engine cannot be started.
- Remove the worn runner by loosening the hex
screws along the length of the part.
- Clean the contact surface and properly install the
new parts (it may also be necessary to replace the
fastening screws since these can also wear).
Fig. Side board