Dynapac PL2000F, Instruction Manual

Page: 229 / 283

218
Maintenance
4812313240.pdf
2017-12-1
Oil filter
The oil filter can be found in the rear section of the
engine compartment and is accessible once the
engine hood has been opened.
Loosen the filter and clean the contact surface.
Slightly lubricate the seal of the new filter and fill the
filter with oil before installing it. Tighten by hand.
Dispose of used filters properly.
After replacing the oil filter, keep an eye on
the seals and the oil pressure display.
Follow Engine operating instructions!
Fuel filter
The fuel filter can be found behind the
maintenance flap of the operator’s control panel.
Dismantle the connection on the underside of the
filter, loosen the filter and clean the contact
surfaces.
Add fuel to the new filter with the new seal and
tighten by hand.
Install the connection on the underside of the filter
with new seals.
Dispose of used filters properly.
After replacing the filter, keep an eye on the
seals.
Follow engine operating instructions!!
Fig. Oil filter
Fig. Fuel filter