Dynapac PL2000F, Instruction Manual

Page: 206 / 283

Operating instructions
195
4812313240.pdf
2017-12-1
Operating instructions – Summary
1. Follow the SAFETY INSTRUCTIONS specified in the Safety Manual.
2. Make sure that all instructions in the MAINTENANCE are followed.
3. Turn the master switch to the ON position.
4. Check that all switches are in position 0 and the Forward/Reverse control is in
neutral.
5. Start the engine and allow it to warm up.
6. Set the gear position switch in the required position.
7. Adjust the engine RPM to the desired position.
8. Set the travel speed to the desired position.
9. Check that the milling drum clears the ground, at least 10cm. Raise the
machine if necessary.
10. Drive the planer. Operate the forward/reverse lever with care.
11. Check the brakes. Remember that the braking distance will be longer if
the hydraulic fluid is cold.
12. IN AN EMERGENCY:
- Press the emergency stop
- Hold the handrails firmly
- Brace yourself for a sudden stop
13. When parking:
- Set the forward/reverse control in NEUTRAL.
14. When lifting: - Refer to the relevant section in the Instruction Manual
15. When towing: - Refer to the relevant section in the Instruction Manual.
16. When transporting: - Refer to the relevant section in the Instruction Manual.
17. Retrieval: - Refer to the relevant section in the Instruction Manual.