Dynapac PL2000F, Instruction Manual

Page: 166 / 283

Machine description
155
4812313240.pdf 2017-12-1
If the control in automatic mode works too sluggishly or is too unstable, the sensitivity
settings of the Cross-Slope sensor should be changed accordingly.
See section “1.6 Sensitivity settings” in the configuration menu.
3) Now switch the controller to automatic
mode (automatic = automatic light on) by
pressing the corresponding A/M key.
The “RAISE” or “LOWER” valve light first
indicates that an existing deviation is being
controlled out. The controller of the MLS508
then automatically holds the milling drum at
the set slope, even if it is moved in height
(manually or by the other side’s control
loop).
With the UP/DOW N keys the set point for
the milling drum’s slope angle can also be
adjusted in automatic mode.
The controller of the MLS 508
automatically moves the milling drum
to the new value and holds it in that
position.