Dynapac PL2000F, Instruction Manual

Page: 263 / 283

252
Maintenance
4812313240.pdf
2017-12-1
Fig. Spray nozzle
Spray nozzles
The spray nozzles are located on
the milling drum cabinet and are
secured against twisting by guides.
To check and clean them, the nozzles can be
removed from the guides through the gaps in
the milling drum cabinet.
- Pull the hose with the nozzle out of the
holder.
- Clean the nozzle with a wire brush. If
necessary, remove or replace the nozzle to
be cleaned.
- Properly reinstall the nozzle and insert it
into the guide.
In case of frost, the feed hoses must be pulled
with the nozzles from the mounts and emptied
completely in order to protect them from
damage.
- Pull the hoses with the nozzles out of the
holders, drain them and let them hang down.
- Before re-commissioning, properly remount
the hoses.