Dynapac PL2000F, Instruction Manual

Page: 242 / 283

Maintenance
231
4812313240.pdf
2017-12-1
1
2
1
Traction units
Planetary gear – oil level check
To check the oil level and while adding oil, the
locking screw for the oil level check (1) must be in
the 9 o’clock position.
The oil level should reach the lower edge of the
hole for the locking screw.
Add oil using the opened filling screw until some
oil exits the hole of the locking screw.
When adding oil, ensure cleanliness.
Oil Change
To drain oil, the drainage screw (2) should be in
the 6 o’clock position and the filling screw (1)
should be in the 9 o’clock position.
Do not change oil when the engine is cold,
but rather directly after the transmission has
stopped.
This ensures that solid particles do not settle.
Wear protective clothing when working
with hot oil. Danger to health if oil contacts
skin.
- Unscrew the oil drainage screw (2), collect
draining oil.
- Remove the filling screw (1).
- After the oil is completely drained, properly
screw in the drainage screw (2) again.
- Add oil using the opened filling screw until
some oil exits the hole of the locking screw.
- Properly screw the filling screw (2) back in.
Collect used oil in a suitable container and
dispose of properly.
When adding oil, ensure cleanliness.
Fig. 1. Oil level check
Fig. 1. Filling screw
2. Draining screw