Dynapac PL2000F, Instruction Manual

Page: 199 / 283

Miscellaneous
188 4812313240.pdf
2017-12-1
Folding out the discharge conveyor
To fold out, proceed as for the folding in process
but in reverse.
The following should be noted:
1. Firstly raise machine as far forward as
possible over traction unit legs then lower as
far as possible to the rear.
2. Ensure that the distance between the bit of
milling drum and the ground is more than
150mm.
3. While the Button (17) is being pressed, the
conveyor continues being folded out until the
button is released.
4. Once the discharge conveyor is folded out
completely, release Button (17) to finish this
process.
When pushbutton is pressed, the discharge
conveyor begins to fold. The pushbutton must be
held down during the entire folding process.
Ensure that there is no one in the machine’s
danger area.
The folding process is complete once the belt is
correctly re-tensioned (visual inspection).
See button function description from “Machine
description” chapter.
18 17
Fig. Switch panel;
Foldable conveyor